D-Link DGS-6608 — управление логированием на удаленный хост через CLI [455/1106]

Превью страниц Страница 455 / 1106

DGS-6600 Series Switch m logging host

CLI Reference Guide

445

logging host

Use the logging host command to log system messages to a remote host.

Remove logging hosts from the configuration with the no logging host

command.

logging host IPADDRESS [port UDP-PORT] [severity {emergency |alert |critical |error

|warning |notice |informational | debugging}] [facility {local0|local1| local2| local3| local4|

local5| local6| local7}]

no logging host [IP-ADDRESS]

Default There is no default syslog server host.

The default syslog UDP port is 514 if not specified.

The default severity of log to be sent to server is informational if not specified.

Syntax Description

IP-ADDRESS Specifies the IP address of the host to be used as the syslog server. IPv4 and IPv6

address are supported.

port UDP-PORT (Optional) The UDP port number to be used for the syslog server. Valid values are

514 or any value from 1024 to 65535.

severity (optional) Specifies the severity of log messages that will be sent to the server.

emergency System is unusable.

alert Action must be taken immediately.

critical critical condition

error error conditions

warning warning condition

notice normal but significant condition

informational informational message

debugging debugging message

facility (optional) Specifies the facility (refer to options listed in the below rows) in the log

messages to be sent to the server.

local0 local use 0

local1 local use 1

local2 local use 2

local3 local use 3

local4 local use 4

local5 local use 5

local6 local use 6

local7 local use 7