D-Link DGS-6608 — настройка времени подавления регистра в сетевых коммутаторах [346/1106]

Превью страниц Страница 346 / 1106

DGS-6600 Series Switch ip pim register-suppresion

CLI Reference Guide

336

ip pim register-suppresion

Use this command to configure the register-suppression time.

ip pim register-suppression SECONDS

Default 60 seconds.

Command Mode Global configuration.

Usage Guideline This command is valid for SM mode.

When a DR receives the register-stop message, it will start the suppression

timer. During the suppression time a DR will stop sending Register-encapsulated

data to the RP.

This timer should be configured on the designated router.

Note: the parameter Register Probe Time in RFC 4601 is fixed to 5 (not

configurable). It is fixed to 5 because the value of the Register Probe Time must

be less than half the value of the Register Suppression Time to prevent a

possible negative value in the setting of the Register-Stop Timer. The minimal

value for Register Suppression Time is 11.

Example This example shows how to configure the register-suppression time to 30

seconds.

Verify the settings by the show ip pim command.

Syntax Description

SECONDS Register suppression time-out value in seconds. The range is 11 to 255.

Switch(config)# ip pim register-suppression 30