D-Link DGS-6608 — настройка направления трафика на порту с помощью dot1x [202/1106]

Превью страниц Страница 202 / 1106

DGS-6600 Series Switch mm dot1x control-direction

CLI Reference Guide

192

dot1x control-direction

Use this command to configure the direction of the traffic on a controlled port as

unidirectional (in) or bidirectional (both).

dot1x control-direction {both | in}

Default bidirectional (both).

Command Mode Interface configuration.

Usage Guideline This command is only valid for physical port interfaces.

This command takes effect only when the global and per-port 802.1x enable

command is configured.

When the port is in force-unauthorized or in an un-authorized state, the traffic

direction controls are based on this command.

When the port is in force-authorized or authorized state, the traffic is allowed in

both directions.

Example The following example shows how to specifies the direction of the traffic through

port eth4.1 as unidirectional.

Verify the settings by entering the show dot1x auth-configuration command.

Syntax Description

both Enable bidirectional control. Both incoming and outgoing traffic through an

802.1X-enabled port are blocked if the port is not successfully authenticated.

in Enable unidirectional control. Incoming traffic through an 802.1X-enabled port is

blocked if the port is not successfully authenticated.

Switch# configure terminal

Switch(config)# interface eth4.1

Switch(config-if)# dot1x control-direction in