D-Link DGS-6608 — настройка PVID для интерфейсов коммутаторов: руководство [584/1106]

Превью страниц Страница 584 / 1106

DGS-6600 Series Switch m pvid VLAN-ID

CLI Reference Guide

574

pvid VLAN-ID

Use the pvid interface configuration command to specify the native VLAN for the

trunk or hybrid interface. Use default interface command to reset to default

setting.

pvid VLAN-ID

default pvid

Default pvid VLAN-ID: 1.(If the port is set to trunk/hybrid mode).

Command Mode Interface configuration.

Usage Guideline The valid interfaces for this command are physical port or port-channel.

An interface can be specified with only one PVID. The succeeding command

overwrites the previous command.

This command is used to change PVID of Trunk or Hybrid port. When an

interface is Access mode, use the access VLAN command to change its PVID

instead of this command.

This command does not affect the VLAN membership and the port’s tag handling

mode (Access, Hybrid or Trunk). Use the trunk allowed-VLAN or hybrid VLAN

command to add the port to the VLAN by the requirement. The specified VLAN

does not need to exist to make the command succeed.

Example This example shows how to set an interface port 1.1 as a hybrid interface with

native VLAN 1000.

Verify the settings by entering the show vlan command.

Syntax Description

pvid VLAN-ID Specifies the PVID for the trunk or hybrid interface.

Switch(config)# interface eth1.1

Switch(config-if)# hybrid vlan 1000 untagged

Switch(config-if)# pvid 1000