D-Link DGS-6608 — настройка SYSLOG серверов для управления логами в сетевых устройствах [456/1106]

Превью страниц Страница 456 / 1106

DGS-6600 Series Switch m logging host

CLI Reference Guide

446

The default facility is local7.

Command Mode management interface mode or Global configuration.

Usage Guideline The number of supporting SYSLOG servers is project dependent. When the

number of configured SYSLOG servers reaches the maximum capacity, a new

SYSLOG server is unable to be configured before and existing entry is deleted

using the command no logging host.

The severity level limits the logging of system messages sent to SYSLOG

servers to only those messages at and up to the specified level. For example, if

the severity is debugging, all logs in the SYSLOG daemon are sent to the log

server host. If the level of log is alert, then only alert and emergency logs are

sent.

The keyword facility specifies the syslog facility in the SYSLOG messages which

are sent to the server.

For the no command, if the IP address is not specified, all logging hosts will be

deleted.

Example The below example shows how to create a log server with the host address

20.3.3.3. The command configures the server to receive logs with a severity level

set to critical.

Verify the settings with the show logging host command.

Switch> enable

Switch# configure terminal

Switch(config)# logging host 20.3.3.3 severity critical