D-Link DGS-6608 — настройка интервала таймера ограничения обрезки в VLAN [343/1106]

Превью страниц Страница 343 / 1106

DGS-6600 Series Switch ip pim prune-limit-interval

CLI Reference Guide

333

ip pim prune-limit-interval

Use this command to configure the time interval for the prune limit timer to limit

the Pruning rate on a LAN.

ip pim prune-limit-interval SECONDS

Default 210 seconds.

Command Mode VLAN interface configuration.

Usage Guideline This command is only valid for the VLAN interface.

This command is valid for PIM-DM only.

This interval is used to configure prune-limit-timer which limits the Pruning rate

on a LAN. It is only used when the Upstream (S,G) state machine is in the

Pruned state. A Prune cannot be sent if this timer is running. This timer is

normally set to default value 210 seconds.

Example The following example configures interface VLAN 1 with the PIM prune limit timer

interval set to 120 seconds.

Verify the settings by entering the show ip pim interface command.

Syntax Description

SECONDS Specifies the value of Prune Limit Timer (in seconds), which is used to prevent

Prune storms on a LAN. The range is 1 to 18000.

Switch(config)# interface vlan1

Switch(config-if)# ip pim prune-limit-interval 120