D-Link DGS-6608 — настройка интервала повторной передачи OSPF для IPv6 [405/1106]

Превью страниц Страница 405 / 1106

DGS-6600 Series Switch ipv6 ospf retransmit-interval

CLI Reference Guide

395

ipv6 ospf retransmit-interval

This command specifies the time between link-state advertisement (LSA)

retransmissions for adjacencies belonging to an interface.

ipv6 ospf retransmit-interval SECONDS [instance-id INSTANCE-ID]

no ipv6 ospf retransmit-interval [instance-id INSTANCE-ID]

Default Seconds: 5.

INSTANCE-ID: 0.

Command Mode Interface configuration.

Usage Guideline After sending an LSA to a neighbor, the router keeps the LSA until it receives an

acknowledgement. In case the router does not receive an acknowledgement,

during the set time (the retransmit interval value), it retransmits the LSA. Set the

retransmission interval value conservatively to avoid needless retransmissions.

The interval should be greater than the expected round-trip delay between two

routers.

Example The following example sets the retransmit interval value to 6 seconds.

Syntax Description

SECONDS The interval the router waits before it retransmits a packet. The valid setting is 1-

65535.

INSTANCE-ID (Optional) Instance identifier. In order to change this ID, configure the "no"

command first. The valid setting is from 0 to 255.

Switch > enable

Switch # configure terminal

Switch (config) # interface vlan1

Switch (config-if)# ipv6 ospf retransmit-interval 6