D-Link DGS-1510-28XMP/ME [146/342] Ipv6 static default route settings

DGS-1510/ME Series Metro Ethernet Switch Web UI Reference Guide

137

Figure 5-2 IPv4 Route Table window

The fields that can be configured are described below:

Parameter Description

Network Address

Click the radio button and enter the destination network address of the route to be

displayed.

Click the Find button to locate a specific entry based on the information entered.

Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses.

To view the following window, click L3 Features > IPv6 Static/Default Route Settings as shown below:

Figure 5-3 IPv6 Static/Default Route Settings window

The fields that can be configured are described below:

Parameter Description

IPv6 Address/Prefix

Length

This field allows the entry of an IPv6 address to be assigned to the static route. Tick

the Default check box to assign to the default route.

Interface Name

The IP Interface where the static IPv6 route is created.

Nexthop Address

The corresponding IPv6 address for the next hop Gateway address in IPv6 format.

Metric (1-65535)

The metric of the IPv6 interface entered into the table representing the number of

routers between the Switch and the IPv6 address above. Metric values allowed are

between 1 and 65535.

Click the Apply button to accept the changes made.

Click the Delete All button to remove all the entries listed.

Click the Delete button to delete the corresponding entry.

Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.