D-Link DGS-1510-28XMP/ME [36/342] System log trap settings

DGS-1510/ME Series Metro Ethernet Switch Web UI Reference Guide

The fields that can be configured or displayed are described below:

Parameter Description

Log Type

In the drop-down menu the user can select the log type that will be displayed.

Severity - When selecting Severity from the drop-down menu, a secondary tick must be

made. Secondary ticks are Emergency, Alert, Critical, Error, Warning, Notice,

Informational and Debug. To view all information in the log, simply tick the All check box.

Module List - When selecting Module List, the module name must be manually entered.

Available modules are MSTP, ERROR_LOG and ERPS.

Attack Log - When selecting Attack Log all attacks will be listed.

Index

A counter incremented whenever an entry to the Switch's history log is made. The table

displays the last entry (highest sequence number) first.

Time

Display the time in days, hours, minutes, and seconds.

Level

Display the level of the log entry.

Log Text

Display text describing the event that triggered the history log entry.

Click the Find button to display the log in the display section according to the selection made.

Click the Clear Log button to clear the entries from the log in the display section.

Click the Clear Attack Log button to clear the entries from the attack log in the display section.

The Switch can record event information in its own log. Click Go to go to the next page of the System Log window.

System Log & Trap Settings

The Switch allows users to configure the system log source IP interface addresses here.

To view the following window, click System Configuration > System Log Configuration > System Log & Trap

Settings as shown below:

Figure 2-23 System Log & Trap Settings window

The fields that can be configured are described below:

Parameter Description

Interface Name

Enter the IP interface name used.

IPv4 Address

Enter the IPv4 address used.

IPv6 Address

Enter the IPv6 address used.

Click the Apply button to accept the changes made for each individual section.

Click the Clear button to clear all the information entered in the fields.

System Severity Settings

The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent. The level at which the

alert triggers either a log entry or a trap message can be set as well. Use the System Severity Settings window to set

the criteria for alerts. The current settings are displayed below the System Severity Table.