D-Link DGS-1510-28XMP/ME [257/342] Trusted host settings

DGS-1510/ME Series Metro Ethernet Switch Web UI Reference Guide

248

Click the Edit button to re-configure the specific entry.

Click the Apply button to accept the changes made.

NOTE: To set the SSH User Authentication Mode parameters on the Switch, a User Account must be

previously configured.

Trusted Host Settings

Up to ten trusted host secure IP addresses or ranges may be configured and used for remote Switch management. It

should be noted that if one or more trusted hosts are enabled, the Switch will immediately accept remote instructions

from only the specified IP address or addresses. If you enable this feature, be sure to first enter the IP address of the

station you are currently using.

To view this window, click Security > Trusted Host Settings as shown below:

Figure 8-69 Trusted Host window

When the user clicks the Edit button, one will be able to edit the service allowed to the selected host.

The fields that can be configured are described below:

Parameter Description

IPv4 Address

Enter an IPv4 address to add to the trusted host list.

Net Mask

Enter a Net Mask address to add to the trusted host list.

Access Interface

Tick the check boxes to select services that will be allowed to the trusted host.

Click the Add button to add a new entry based on the information entered.

Click the Delete All button to remove all the entries listed.

Click the Edit button to re-configure the specific entry.

Click the Delete button to remove an entry.