Icom IC-207H [23/80] I tuning step selection

SETTING A FREQUENCY

■ Tuning step selection

Tuning steps are the minimum frequency change increments

when you rotate the tuning dial or push the [Y] or [Z]

switches on the microphone. The following tuning steps are

available:

• 5 kHz • 10 kHz • 12.5 kHz • 15 kHz

• 20 kHz • 25 kHz • 30 kHz • 50 kHz

NOTE: For convenience, select a tuning step that

matches the frequency intervals of repeaters in your area.

➀ Push [BAND] to select the desired band, if necessary.

➁ Push [V/MHz] to select VFO mode if another mode has

been selected.

➂ Push [SET] one or more times until “tS” appears as shown

below.

• Pushing [MONI] reverses the order of selection.

• Cancel the DTMF memory function in advance. (p. 48)

➃ Rotate the tuning dial to select the tuning step.

➄ Push [V/MHz] to exit set mode.

Ä Push [BAND] to select the operating band, if

necessary.

Å Push [VFO] to select VFO mode.

Ç Push [F SET] one or more times until “tS” ap-

pears as shown previously.

• Push [ENT] to reverse the order of selection.

• Cancel the DTMF memory function in advance.

(p. 48)

É Push [Y] or [Z] to select the tuning step.

Ñ Push [CLR] to exit set mode.

USING

SET MODE

25 kHz tuning step

15 kHz tuning step

SET