Icom IC-207H [51/80] Dtmf memory encode

DTMF MEMORY ENCODER

■ Programming a DTMF code

DTMF codes are used for autopatching, accessing repeaters,

controlling other equipment, etc. The transceiver has 14

DTMF memory channels (d0– d9, dA–dd) for storage of often-

used DTMF codes of up to 16 digits.

NOTE: DTMF memory channels are commonly used for

both bands. Therefore, programming each band is not

necessary.

➀ Push for one sec. and “d” appears in place of the

100 MHz digit as shown below.

➁ Push [SET] to enter the programming condition.

➂ Rotate the tuning dial to select the desired channel.

➃ Push [SET] or [MONI] to select the cursor.

➄ Rotate the dial to select a digit.

•“E” stands for “M” and “F” stands for “#.”

➅ Repeat steps ➃ and ➄ until the last digit is entered.

• The S/RF indicator shows the digit group. The indication in-

creases every 6 digits.

• Select “–” to clear the remaining digits when programming over a

previously used memory channel.

➆ Push [V/MHz] exit the programming condition.

DTMF

■ Clearing the DTMF memory

contents

➀ Push for 1 sec. to turn the DTMF memory encoder

ON.

➁ Push [SET] to enter the programming condition.

➂ Rotate the tuning dial to select the desired channel.

➃ Push [SET] to activate the 1st digit.

➄ Rotate the tuning dial to select “–” and clear the memory

channel contents.

➅ Push the tuning dial to exit the programming condition.

DTMF

“d” appears in place of

the 100 MHz digit.