Icom IC-V8 [49/80] I programmed scan

SCAN OPERATION

■ Programmed scan

Programmed scan repeatedly scans between two user pro-

grammed frequencies (memory channels “1A–3A” and “1b–3b”) or

scans between upper and lower band edges. This scan is useful

for checking for signals within a speciﬁc frequency range such as

repeater output frequencies, etc. Scans between lower (start) and

high (stop) frequency.

q Push [D•

CLR

] to select VFO mode, if necessary.

w Push [A•

FUNC

], then push [5•

SCAN

] to start the scan, then a se-

lected scan edge appears as “P1,” “P2,” “P3” or “AL.”

• To change the scan edge, push [A•

FUNC

] then push [8•

SET

] several

times until the desired scan edge appears.

• “AL” for full scan, “P1”, “P2” and “P3” for programmed scan be-

tween the programmed scan edge channels as “1A”–“1b,”

“2A”–“2b” and “3A”–“3b.”

• To change the scan direction, push [Y] or [Z].

• When [VOL] is assigned as tuning dial, rotate [VOL] to change the

scan direction. (pgs. 17, 53)

e Push [D•

CLR

] to stop the scan.

NOTE: Scan edges, 1A–3A/1b–3b, must be programmed in ad-

vance.

Program them in the same manner as regular memory chan-

nels. (p. 26)

If the same frequencies are programmed into the scan edges,

programmed scan will not proceed.

IC-V8_New.qxd 02.5.23 10:55 Page 33 (1,1)