Moxa WDR-3124A-EU-T [48/94] Network gateway preference in client router mode

WDR-3124A Web Console Configuration

3-25

Network Gateway Preference (in Client-Router mode)

In Client-Router mode, the WDR-3124A provides two WAN interfaces: WLAN and cellular.

When both WAN interfaces are connected, the WDR-3124A uses the WLAN interface as the default gateway.

You can use the Network Gateway Preference screen to enable WLAN connection tests to determine

whether to switch over to the cellular interface.

The following table provides the field descriptions.

Field Description Default setting

WLAN alive check Select Enable to set the WDR-3124A to ping a remote host on the

WLAN interface to test the connection.

Disable

WLAN ping host 1/2 Enter the IP address of a remote host for the WLAN interface ping

test.

WLAN alive check

duration

Enter the number of seconds the WDR-3124A is to ping a remote

host for the alive check.

If the WDR-3124A cannot ping a remote host after the timeout, the

WDR-3124A uses the cellular interface as the default gateway.

WLAN SNR health

check

Select Enable to set the WDR-3124A to check the signal-to-noise

ratio (SNR).

Disable

Cellular-to-WLAN

switchover

Specify the threshold for the signal level before the WDR-3124A

uses the cellular interface as the default gateway.