Nissan Note [9/104] Side window glass

SIDE WINDOW GLASS

GW-9

● While the urethane adhesive is curing, open a door window. This will prevent the glass from being forced

out by passenger room air pressure when a door is closed.

● The molding must be installed securely so that it is in position and leaves no gap.

● Inform the customer that the vehicle should remain stationary until the urethane adhesive has completely

cured (preferably 24 hours). Curing time varies with temperature and humidity.

WARNING:

● Keep heat and open flames away as primers and adhesive are flammable.

● The materials contained in the kit are harmful if swallowed, and may irritate skin and eyes. Avoid

contact with the skin and eyes.

● Use in an open, well ventilated location. Avoid breathing the vapors. They can be harmful if

inhaled. If affected by vapor inhalation, immediately move to an area with fresh air.

● Driving the vehicle before the urethane adhesive has completely cured may affect the perfor-

mance of the side window in case of an accident.

CAUTION:

● Do not use an adhesive which is past its usable term. Shelf life of this product is limited to six

months after the date of manufacture. Carefully adhere to the expiration or manufacture date

printed on the box.

● Keep primers and adhesive in a cool, dry place. Ideally, they should be stored in a refrigerator.

● Do not leave primers or adhesive cartridge unattended with their caps open or off.

● The vehicle should not be driven for at least 24 hours or until the urethane adhesive has com-

pletely cured. Curing time varies depending on temperature and humidities. The curing time will

increase under lower temperature and lower humidity.

Repairing Water Leaks

Leaks can be repaired without removing and reinstalling glass.

If water is leaking between the urethane adhesive material and body or glass, determine the extent of leakage.

This can be done by applying water to the side window area while pushing glass outward.

To stop the leak, apply primer (if necessary) and then urethane adhesive to the leak point.