Nec PX700W [32/244] Projecting an image basic operation

2. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

Whenyourstturnontheprojector,youwillgettheStartupmenu.Thismenugivesyoutheopportunitytoselectone

ofthe27menulanguages.

Toselectamenulanguage,followthesesteps:

1. Usethe, ,  or buttontoselectoneofthe27lan-

guagesfromthemenu.

2. PresstheENTERbuttontoexecutetheselection.

Afterthishasbeendone,youcanproceedtothemenuopera-

tion.

Ifyouwant,youcanselectthemenulanguagelater.

(→[LANGUAGE]onpage98and116)

NOTE:

• Turningthepowerbackondirectlyafteritisturnedoff(bydirectpoweroff)whileanimageisbeingprojectedcanresultin

malfunction. Be sure to wait at least 1 second before turning the power back on.

• Keepthelenscapoffthelenswhiletheprojector’spowerison.

If the lens cap is on, it could be warped due to high temperature.

• Ifoneofthefollowingthingshappens,theprojectorwillnotturnon.

- If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the

projectorwillnotturnontoprotecttheinternalsystem.Ifthishappens,waitfortheprojector’sinternalcomponentstocool

down.

- Startingunderlowtemperatureconditions

 Iftheusageenvironmenttemperatureislowerthantheprojector’soperatingtemperature,theTEMP.indicatorwillash.Increase

theusageenvironmenttemperatureto0°Corhigherandturnontheprojectoragain.

 Ifyouturnontheprojectorataround0°C,itmaytake5minutestowarmuptheprojector.

 Duringwarm-up,theTEMP.indicatorwillash.Whenthewarm-upiscompleted,theTEMP.indicatorwilllightout.

- Whenthelampreachesitsendofusablelife,theprojectorwillnotturnon.Ifthishappens,replacethelamp.

- IftheSTATUSindicatorlightsorangewiththepowerbuttonpressed,itmeansthatthe[CONTROLPANELLOCK]isturnedon.

Cancelthelockbyturningitoff.(→ page 122)

- Ifthelampfailstolight,andiftheLAMP1orLAMP2indicatorashesonandoffinacycleofsixtimes,waitafullminuteand

then turn on the power.

• WhilethePOWERindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoffbyusingthepowerbutton.

• Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamplightingis

stabilized.

• Whentheprojectoristurnedon,itmaytakesometimebeforethelamplightbecomesbright.

• Ifyouturnontheprojectorimmediatelyafterthelampisturnedofforwhenthetemperatureishigh,thefansrunwithoutdisplay-

ing an image for some time and then the projector will display the image.