Icom IC-V8000 [65/88] Pager code squelch

PAGER/CODE SQUELCH

z Push [BANK/OPTION] for 1 sec. to select

pager mode.

• 100 MHz digit shows “P.”

x Push [

SET

B(D-OFF)] to enter to the code

set mode.

• One of either “CP” or “C0” to “C6” blinks.

•“C0” is the ID code and “C1” to “C6” are the

transmit code.

c Push [Y] or [Z] to select the desired code

channel.

v Enter the desired 3-digit code via the key-

pad.

b Push [

SET

B(D-OFF)] to set the channel for

“receive inhibit” or “receive accept.”.

• When “receive inhibit” is set, “SKIP” appears.

• Code channel C0 cannot be set as “receive in-

hibit.”

• See right above for “receive accept” and “re-

ceive inhibit” details.

n Repeat steps c to b to set additional

code channels, if desired.

m Push [

CLR

A(MW)] to exit code set mode.

• Receive accept/receive inhibit

➥ “Receive accept” (“SKIP” indicator does not appear) ac-

cepts pager calls when the transceiver receives a signal

with a code the same as that in the code channel.

➥ “Receive inhibit” (“SKIP” indicator appears) rejects calls

even when the transceiver receives a code the same as

that in the code channel. Transmit codes should therefore

be programmed for “receive inhibit,” otherwise the trans-

ceiver will not reject unnecessary calls.

• Pager/code squelch operation during channel indication

To use these functions in channel indication, the pager/code

squelch setting must be programmed with other memory con-

tents before selecting channel number indication.

BANK/OPTION