Icom IC-RX7 [58/108] Memory channel programming

New2001

MEMORY PROGRAMMING

New2001

■

Memory channel programming

q Push and hold [HOLD V] for 1 sec. to select VFO mode.

Set the desired frequency, if desired:

• Frequency or any other data can be set while in CH program-

ming state.

➥ Select the desired band with [v] or [w].

➥ Set the desired frequency with [DIAL].

➥ Or set the desired frequency with keypad directly.

In this case, the band and frequency settings with

[v]/[w] and [DIAL] as above are not required.

➥

Set other data (e.g. offset frequency, duplex direction,

tone squelch, etc.) in the menu screen.

Push and hold [ENT MW] for 1 sec. to enter the memory

programming mode.

• 1 short and 1 long beep sound.

• Category selection screen appears.

✔ STORING SEARCHED FREQUENCY:

Another way to store information into memory channels is as

follows:

Start a search.

• Search pauses when a signal is received.

• Rotate [DIAL] to restart the search.

w Push [HOLD V] to hold the search, if you want to store the

paused frequency into memory channel.

Push and hold [ENT MW] for 1 sec. to enter the memory

programming mode.

Push [r] or [s] (or rotate [DIAL]) to select the desired

category or “ADDITION,” then push [ENT MW].

• When “ADDITION” is selected, new category can be pro-

grammed (see p. 52 for new category programming details).

t Push [r] or [s] (or rotate [DIAL]) to select the desired

group or “ADDITION,” then push [ENT MW].

• When “ADDITION” is selected, new group can be programmed

in the category (see p. 53 for new group programming details).

NOTE: The previous selected category or group are

selected automatically when two or more memory channels

are programmed continuously.