Kawasaki KLV1000 (2004) [230/529] Self diagnosis reset procedure

FI SYSTEM 4-29

SELF-DIAGNOSTIC PROCEDURES

• Don’t disconnect couplers from ECM, battery cable from bat-

tery, ECM ground wire harness from engine or main fuse

before confirming malfunction code (self-diagnostic trouble

code) stored in memory. Such disconnection will erase mem-

orized information in ECM memory.

• Malfunction code stored in ECM memory can be checked by

the special tool.

• Before checking malfunction code, read SELF-DIAGNOSIS

FUNCTION “USER MODE and DEALER MODE” (4-23,

-24 and -25) carefully to have good understanding as to what

functions are available and how to use it.

• Be sure to read “PRECAUTIONS for Electrical Circuit Ser-

vice” (4-5) before inspection and observe what is written

there.

• Remove the seat.

• Connect the special tool to the dealer mode coupler

" at the

wiring harness, and start the engine or crank the engine for

more than 4 seconds.

• Turn the special tool’s switch ON and check the malfunction

code to determine the malfunction part.

\ 09930-82710: Mode select switch

SELF-DIAGNOSIS RESET PROCEDURE

• After repairing the trouble, turn OFF the ignition switch and

turn ON again.

• If the malfunction code indicates (C00), the malfunction is

cleared.

• Disconnect the special tool from the dealer mode coupler.

09930-82710 : Mode select switch