D-Link DGS-3312SR [33/290] Ip address assignment

DGS-3312SR Stackable Gigabit Layer 3 Switch

IP Address Assignment

Each Switch must be assigned its own IP Address, which is used for communic ork manager or

Switch’s default IP address is 10.90.90.90. You can change

our networking address scheme.

The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found

from the initial boot console screen – shown below.

ation with an SNMP netw

other TCP/IP application (for example BOOTP, TFTP). The

the default Switch IP address to meet the specification of y

Figure 2-9. Boot screen

The Switch’s MAC address can also be found from the Web management program on the Switch Information (Basic

Settings) window on the Configuration menu.

The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address

can be automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be

known.

The IP address may be set using t

1. Starting at the com

he Command Line Interface (CLI) over the console serial port as follows:

mand line prompt, enter the commands config ipif System ipaddress

in CIDR notation.

xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x’s represent the IP address to be assigned to the IP interface

named System and the y’s represent the corresponding subnet mask.

2. Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x’s represent the IP

address to be assigned to the IP interface named System and the z represents the corresponding number of subnets

The IP interface named System on the Switch can be assigned an IP address and subnet mask that can then be used to

connect a management station to the Switch’s Telnet or Web-based management agent.