D-Link DGS-3312SR [223/290] Stack information

DGS-3312SR Stackable Gigabit Layer 3 Switch

Stack Information

The DGS-3312SR Switch can be used as a standalone high-capacity Switch or be used in a stacked arrangement. There are

two hardware requirements to use the Switch in a stacked group:

1. The proper module(s) must be installed to use the DES-3226S. One or two DEM-540, DEM-340T or the DEM-

340MG Stacking modules must be installed in order to use the Switch in a stacked configuration.

2. Slave Switch units in a stacked Switch group must be ne of the Switch models intended for use with the DGS-

3312 ese two

switc

One stacking module can be installed to stack up to four additional slave Switch units or two modules can be installed to

stack up to eight additional slave Switch units.

The DES-3250TG will stack with the DGS-3312SR only with a gigabit Ethernet connection, namely one the first four

Mini-GBIC combo ports to the left of the front panel of the Switch or through the use of a gigabit Ethernet module. One of

these ports MUST be connected to the Mini-GBIC combo port number 50 to the far right of the DES-3250TG for the

proper stacking implementation to function correctly.

The DES-3226S will stack with the DGS-3312SR with a gigabit Ethernet connection or over IEEE 1394 fire wire cabling.

One of these ports MUST be connected to module port number 26 to the far right of the DES-3226S for the proper stacking

implementation to function correctly.

The web manager can be used to enable or disable the stacking mode and to enable stacking for any of the built-in

combination ports.

The Switch stack displayed in the upper right-hand corner of your web-browser is a virtual representation of the actual

stack. The icons appear in the same order as their respective Switches.

When the Switches are properly interconnected, information about the resulting Switch stack is displayed in the Stack

Mode Setup window. To view stacking information or to enable/disable the stacking mode, click the Stack Information

link in the Monitoring folder.

SR, namely the DES-3226S and the DES-3250TG Switches. The user may employ any combination of th

hes in a star topology.

Figure 8- 1. Stack Mode Setup (stacking disabled) window

the stacking mod

ect Enable from

2. Click on the Apply button.

king for one o

To enable e, follow the steps listed below.

1. Sel the Stack Mode State drop-down menu.

To enable stac r more built-in combination ports, do the following:

210