Gree HOME GMV [90/367] Wired remote controller for hydro unit

Gree HOME GMV [90/367] Wired remote controller for hydro unit
Dc Inverter VRF plus Water Heater Solution Service Manual CONTROL
86
4.1.3 Installation
1 324
Fig.4.3 Installation of wired controller
Notice for installation under the guidance of Fig.10
1. Cut off power supply before installing the electrical components.It is forbidden to carry out the installation with
power on;
2. Get one end of the 4 core communication cable and put it through the rectangular hole on the base board on the
wired controller;
3. Hold the base board of controller on the wall, and then fix it to the wall with M4x25 screw;
4. Plug the 4 core communication cable into the slot on the wired controller, and then fix the controller panel with
base board together;
4.2 WIRED REMOTE CONTROLLER for Hydro unit
4.2.1 Introduction of Functions
Wired controller shall be used with hydro-box and its main functions are as follows:
Mode Setting: There are 4 kinds of modes that are heating,energy-saving, presetting and night
Temp Setting Range: 3558℃(max.setting temp in energy-saving mode is 50 ℃)
Manual ON/OFF; Timer ON/OFF;(the timer is clock timer)
Current Time Display
Clean
Fast Water Heating
Operational Parameter Inquiry
User Parameter Setting
Touchable Buttons
Note
Don’t install the wire controller in wet environment or where it is exposed under sun
Don’t knock, throw or frequently disassemble wired controller.
Don’t operate the wired controller with wet hand.
4.2.2 Control Interface
Display of Wired Controller
SN 1 2 3 4
Name
Casing base, installed into the
wall
Controller
Soleplate
Screw M4X25
Controller
Panel

Содержание

Скачать