D-Link DWC-1000 [170/368] D link dwc 1000 user manual 170

D-Link DWC-1000 User Manual 170

Section 5 - Advanced Network Conguration

Field Description

OSPFv3 Enable Toggle ONtoenableOSPFv3.

Interface DisplaysthephysicalnetworkinterfaceonwhichOSPFv3isEnabled/Disabled.

Priority

HelpstodeterminetheOSPFv3designatedcontrollerforanetwork.Thecontrollerwiththehighest

priority will be more eligible to become Designated Controller. Setting the value to 0 makes the

controller ineligible to become Designated Controller. The default value is 1. Lower the value means

higher the priority.

Hello Interval

Thenumberof seconds forHello Interval timer value.Enterthe number in seconds thatthe Hello

packet will be sent. This value must be the same for all controllers attached to a common network. The

default value is 10 seconds.

Dead Interval

The number of seconds that a device’s hello packets must not have been seen before its neighbors

declare the OSPF controller down. This value must be the same for all controllers attached to a

commonnetwork.Thedefaultvalueis40seconds.OSPFrequirestheseintervals tobeexactly the

samebetweentwoneighbors.Ifanyoftheseintervalsaredierent,thesecontrollerswillnotbecome

neighbors on a particular segment.

Cost EnterthecostofsendingapacketonanOSPFv3interface.

Save Click Save to save your settings.