D-Link DWC-1000 [260/368] Ssl vpn

D-Link DWC-1000 User Manual 260

Section 7 - VPN

SSL VPN

SSLVPNPoliciescanbecreatedonaGlobal,Group,orUserlevel.UserlevelpoliciestakeprecedenceoverGroup

level policies and Group level policies take precedence over Global policies. These policies can be applied to a

specicnetworkresource,IPaddress,orIPrangesontheLAN,ortodierentSSLVPNservicessupportedbythe

switch. The List of Available Policies canbelteredbasedonwhetheritappliestoauser,group,orallusers(global).

ToaddaSSLVPNpolicy,youmustrstassignittoauser,group,ormakeitglobal(i.e.,applicabletoallSSLVPN

users).Ifthepolicyisforagroup,theavailableconguredgroupsareshowninadrop-downmenuandone

theIPaddresses).Forapplyingthepolicytoaddressestheportrange/portnumbercanbedened.

The nal steps require the policy permission to be set to either permit or deny access to the selected addresses

ornetworkresources.AswellthepolicycanbespeciedforoneorallofthesupportedSSLVPNservices(i.e.,

VPNtunnel).

Oncedened,thepolicygoesintoeectimmediately.Thepolicyname,SSLserviceitappliesto,destination

(networkresourceorIPaddresses),andpermission(deny/permit)isoutlinedinalistofconguredpoliciesfor

the controller.

Note:YoumustenableRemoteManagement.Referto“VLANs”onpage150.

TocreateanewSSLVPNpolicy:

1. Makesureyouhaveenabledremotemanagementandhavecreateduser(s)andgroup(s)toassignto