Tohatsu MFS 30 — инструкция по установке и обслуживанию двигателя [171/319]

Превью страниц Страница 171 / 319

5-55

25/30 2006

16. Put some engine oil into oil passage g of oil filter bolt before

installing oil filter.

14. Install crank case to cylinder block.

15. Tighten crank case M8 bolts in two steps to specified torque

in the order shown. Then, tighten M6 bolts in two steps to

specified torque.

~ Crank Case Bolts (M8) :

First Tightening Torque : 10 N·m ( 7 lb·ft ) [ 1.0 kgf·m ]

Final Tightening Torque : 24 N·m ( 17 lb·ft ) [ 2.4 kgf·m ]

~ Crank Case Bolts (M6):

First Tightening Torque : 6 N·m ( 4 lb·ft ) [ 0.6 kgf·m ]

Final Tightening Torque : 12 N·m ( 8.5 lb·ft ) [ 1.2 kgf·m ]

11. Install bearing half to crank case.

13. Apply sealing agent to mating surface of crank case (both

sides, overall).

1141C1141C

1141C

1141C1141C

1141C

• Be sure that individual bearings are installed to

their original locations.

• Install bearings with their projection fit into

crank case groove.

• Degrease mating surfaces of cylinder and

crank case.

• Be careful not to allow sealing agent to adhere

to bearing.

• Apply Three Bond 1141C to both sides and

overall face of mating surfaces, taking care

that no excessive agent protrudes.

12. Apply 4 stroke engine oil to bearings.

MFS25_30_ch05.qxd 06.3.9 4:49 PM ページ 55