Tohatsu MFS 30 — установка блока PTT и газового амортизатора для лодочного мотора [242/319]

Превью страниц Страница 242 / 319

Bracket

7-32

25/30 2006

26)

Installation of PTT Unit/Gas Shock Absorber

1. Fully tilt up outboard motor and lock with tilt stopper 1.

2. Reinstall bushings 2, 3 and 4 to their original positions.

3. Install PTT unit 5 or gas shock absorber 6, and then

cylinder shaft (lower) 7.

4. Attach "C" ring 8.

5. Connect lead wires to battery to fully stretch tilt rod.

6. Install cylinder shaft (upper) 9 and tighten bolt 0.

7. Run PTT motor lead wires through hole and secure them

using clamps q and w and screws e.

8. Connect earth lead r to PTT unit bottom and secure with

bolt t.

9. Install thrust rod y.

Retract tilt rod a little.

WARNING

Be sure to lock outboard motor with tilt

stopper after tilting up. Leaving outboard

motor without locking may lead to

accidental descent due to reduction of PTT

hydraulic pressure.

2, 3 and 4 Bushings

5 PTT Unit

6 Gas Shock Absorber

7 Cylinder Pin (Lower)

8 "C" Ring

9 Cylinder Pin (Upper)

0 Bolt

q and w Clamps

e Screw

r Earth Lead

t Bolt

y Thrust Rod

MFS25_30_ch07.qxd 06.3.9 4:57 PM ページ 32