Tohatsu MFS 30 — установка аккумулятора и приборов: пошаговое руководство [309/319]

Превью страниц Страница 309 / 319

10-5

25/30 2006

2) Installation of Battery

When using battery, select the one with capacity ranging from

12V 70AH (350CCA or 465MCA) to 12V 100AH(775CCA or

1000MCA at below freezing temperature).

1 Battery should be stored in battery storage box and

secured to hull to prevent it from falling due to rolling or

pitching or any shock in the place where it is protected

from water spray.

2 When connecting battery cables, connect positive cable

(red) and then negative cable (black). (Reverse the order

when disconnecting.)

Positive cable is the one with red tube on the terminal end.

• Tachometer

Set selector 1 to "12P" on the back of the meter.

CAUTION

• Before using battery, thoroughly read

warning label.

• Do not disconnect battery cable during

engine operation.

Installation of Meters and Battery

1) Installation of Meters

When installing meters, select a place on the dash board 1

where operator can watch them easily and they are not

exposed to water spray.

The meters can be installed on the dash board 1 of 2 to

11mm thick. When the thickness is over 11mm, cut fitting

plate 2 so that the meters can be installed.

• Angle of Installation

Install meters so that the angle is in between 50 to 80

degrees from horizontal plane.

3 Large Sized Meters : Tachometer 3 and Speedometer

Installation Opening Diameter : 85mm (3-3/8 in)

4 Small Sized Meters : Trim Meter 5, Volt Meter, etc.

Installation Opening Diameter : 53mm (2-1/8 in)

MFS25_30_ch10.qxd 06.3.9 5:04 PM ページ 5