Tp-Link T1700G-28TQ V2 — настройка статической маршрутизации: пример и руководство [446/772]

Превью страниц Страница 446 / 772

Configuring Static Routing Example for Static Routing

Configuration Guide

421

Example for Static Routing

5.1 Network Requirements

As shown below, Host A and Host B are on different network segments. To meet business

needs, Host A and Host B need establish a connection without using dynamic routing

protocols to ensure stable connectivity.

Figure 5-1 Network Topology

Host A

10.1.1.100/24

Host B

10.1.2.100/24

Gi1/0/1

Gi1/0/2

Gi1/0/1

Gi1/0/2

10.1.1.1/24 10.1.10.1/24

10.1.10.2/24

10.1.2.1/24

Switch A Switch B

5.2 Configuration Scheme

To implement this requirement, you can configure the default gateway of host A as

10.1.1.1/24, the default gateway of host B as 10.1.2.1/24, and configure IPv4 static routes

on Switch A and Switch B so that hosts on different network segments can communicate

with each other.

Demonstrated with T1700G-28TQ, the following sections provide configuration procedure

in two ways: using the GUI and using the CLI.

5.3 Using the GUI

The configurations of Switch A and Switch B are similar. The following introductions take

Switch A as an example.

1) Choose the menu Routing> Interface > Interface Config to load the following page.

Create a routed port Gi1/0/1 with the mode as static, the IP address as 10.1.1.1, the

mask as 255.255.255.0 and the admin status as Enable. Create a routed port Gi1/0/2

with the mode as static, the IP address as 10.1.10.1, the mask as 255.255.255.0 and the

admin status as Enable.