Home
Главная
Ski-Doo
Снегоход
Ski Doo MX Z 2005
Инструкция по эксплуатации Страница: 1305

Ski-Doo Ski Doo MX Z 2005 [1305/1429] Installation of battery

Section08ELECTRICAL

Subsection 04 (BATTERY)

Charging a Very Flat or Completely

Discharged Battery

Skandic LT E

Unless this procedure is properly followed, a good

battery may be needlessly replaced.

– Measure the voltage at the battery posts with

an accurate voltmeter. If it is below 10 volts,

the battery will accept current at very low rate,

in term of milliamperes, because electrolyte

is nearly pure water as explained above. It

could be some time before the charging rate

increases. Such low current flow may not be

detectable on some charger ammeters and the

battery will seem not to accept any charge.

– Only for this particular case, set the charger to

ahighrate.

NOTE: Some chargers have a polarity protection

feature which prevents charging unless the charg-

er leads are connected to the correct battery ter-

minals. A completely discharged battery may not

have enough voltage to activate this circuitry, even

though the leads are connected properly. This will

make it appear that the battery will not accept

a charge. Follow the charger manufacturer's in-

struction telling how to bypass or override this cir-

cuitry so that the charger will turn on and charge

a low-voltage battery.

– Since the battery chargers vary in the amount

of voltage and current they provide, the time

required for the battery to accept measurable

chargercurrentmightbeuptoapproximately

10 hours or more.

– If the charging current is not up to a measurable

amount at the end of about 10 hours, the bat-

tery should be replaced.

– If the charging current is measurable before the

end or at the end of about 10 hours, the battery

is good and charging should be completed in the

normal manner as specified in Activation of a

new battery.

– It is recommended that any battery recharged

by this procedure be load tested prior to return-

ing it to service.

All Except Skandic LT E



WARNING

Always wear safety glasses and charge in

a ventilated area. Never charge or boost

battery while installed on vehicle. Do not

open the sealed caps during charging. Do

not place battery near open flame.

CAUTION: If battery becomes hot, stop charg-

ing and allow it to cool before continuing.

NOTE: Sealed VRLA batteries have an internal

safety valve. If battery pressure increases due to

overcharging, the valve opens to release excess

pressure, preventing battery damage.

Perform BATTERY CHARGE TESTING above then

proceed as described here.

An automatic charger is the fastest and most con-

venient way for error-proof charging.

NOTE: If battery cannot be recharged using the

following charging chart, replace battery.

When using a constant current charger, charge

battery according to the chart below.

Battery Voltage Below 12.8 V

STANDARD CHARGING

(RECOMMENDED)

BATTERY

TYPE

TIME CHARGE

YTX20L-BS

4 – 9 hours

YTX24HL-BS

5 – 10 hours

QUICK CHARGING

BATTERY

TYPE

TIME CHARGE

YTX20L-BS 50 minutes

YTX24HL-BS 1 hour

10 A

INSTALLATION OF BATTERY

Skandic LT E

Ensure vent tube is properly installed on battery

elbow.

Connectventtubetovehiclefittingonfrontframe.

446 mmr2005-045

Ski-Doo Ski Doo MX Z 2005 [1305/1429] Installation of battery

Содержание

Похожие устройства