Ski-Doo Ski Doo MX Z 2005 [34/1429] Drive system

Ski-Doo Ski Doo MX Z 2005 [34/1429] Drive system
Section 01 MAINTENANCE
Subsection 03 (PRESEASON PREPARATION)
Air Filter
Check that inside of air silencer is clean and dry
then properly reinstall the filter.
CAUTION: These snowmobiles have been cal-
ibrated with the filter installed. Operating the
snowmobile without it, may cause engine dam-
age.
Throttle Body (SDI)
Remove the throttle body from vehicle.
Using the pulley flange cleaner (P/N 413 711 809),
remove the dirt ejected by the drive belt from the
throttle plate and from both throttle body bores.
After throttle body installation, adjust throttle and
injection oil cables.
Injection Oil
Add 500 mL (17 U.S. oz) of recommended injec-
tion oil to the first full filled fuel tank.
DRIVE SYSTEM
Drive Belt
Inspect belt for cracks, fraying or abnormal wear.
Replace if necessary.
Make sure to install the proper belt with arrow
printed on belt pointing front of vehicle.
Drive and Driven Pulley
Clean drive and driven pulleys sheaves with pulley
flange cleaner (P/N 413 711 809).
Retorque if necessary drive pulley screw to
90 to 100 Nm (66 to 74 lbfft).
Brake Fluid
Check brake fluid in reservoir for proper level. Add
fluid(DOT4)asrequired.
CAUTION: Use only (DOT 4) brake fluid from a
sealed container. Do not store or use a started
bottle of brake fluid.
Brake Hose, Pads and Disk
Inspect brake hose for wear, deterioration or dam-
age, replace if necessary.
Inspect brake pads for proper thickness. Refer to
DRIVETRAIN section and the appropriate subsec-
tion.
Remove any rust built-up on braking surfaces.
Clean brake disk braking surfaces with pulley
flange cleaner (P/N 413 711 809).
Chaincase Oil
Check chaincase oil for proper level. Add recom-
mended chaincase oil as required.
MODELS CHAINCASE OIL
Fan Cooled
XP-S chaincase oil
(P/N 413 801 900)
Liquid Cooled
XP-S synthetic chaincase oil
(P/N 413 803 300)
Track Tension and Alignment
Verify track tension and alignment, refer to DRIVE
SYSTEM section and the appropriate subsection.
NOTE: Track tension and alignment are interrelat-
ed. Do not adjust one without checking the other.
Track tension procedure must be carried out prior
to track alignment.
ELECTRICAL SYSTEM
Battery (if so equipped)
Verify that battery is fully charged, if not, refer to
the appropriate charging procedure in ELECTRI-
CAL SYSTEM section and the appropriate subsec-
tion.
WARNING
Always wear safety glasses and charge in
a ventilated area. Never charge or boost
battery while installed on vehicle. Do not
open the sealed caps during charging. Do
not place battery near open flame.
Spark Plugs
Once preseason preparation is done, start engine
with the old spark plug(s) to burn excess stor-
age oil. Then, install new properly gapped spark
plug(s).
VEHICLE
Headlamp Beam Aiming
Verify beam aiming and adjust if necessary, refer
to ELECTRICAL SYSTEM section and the appro-
priate subsection.
8 mmr2005-062

Содержание

Скачать