Ski-Doo Ski Doo MX Z 2005 [30/1429] Fuel system

Ski-Doo Ski Doo MX Z 2005 [30/1429] Fuel system
Section 01 MAINTENANCE
Subsection 02 (STORAGE)
Proceed as follows:
Start the engine and allow it to run at idle speed
until the engine reaches its operating tempera-
ture.
WARNING
Ensure the track is free of particles which
could be thrown out while it is rotating.
Keep hands, tools, feet and clothing clear
of track. Ensure no one is standing in close
proximity to the vehicle.
Stop the engine.
Remove air silencer to spray storage oil into each
carburetor/throttle body.
Restartengineandrunatidlespeed.
Inject storage oil until the engine stalls or until a
sufficient quantity of oil has entered the engine
(approximately half a can).
With the engine stopped, remove the spark plug
and spray storage oil (Canada) (P/N 413 711 600)
or storage oil (USA) (P/N 413 711 900) into each
cylinder.
Crank slowly 2 or 3 revolutions to lubricate cylin-
ders.
Reinstall the spark plugs and air silencer.
WARNING
This procedure must only be performed in a
well-ventilated area. Do not run engine dur-
ing storage period.
Cooling System
For coolant replacement on liquid cooled models,
refer to ENGINE section.
Crankshaft PTO Seal
Make sure there is no grease coming out from
crankshaft PTO seal, if so replace seal, refer to
ENGINE section.
Injection Oil Filter
Replace injection oil filter, refer to ENGINE sec-
tion.
Rags in Air Intake and Exhaust System
Block air intake hole and exhaust system hole us-
ing clean rags.
FUEL SYSTEM
Fuel Stabilizer
It is critical to use the fuel stabilizer (P/N 413 408
600) (250 mL) to prevent fuel deterioration, gum
formation and fuel system components corrosion.
Follow manufacturers instructions for proper use.
Pour fuel stabilizer in fuel tank prior to starting en-
gine for internal parts lubrication so that stabilizer
flows everywhere in fuel system. Fill up fuel tank
completely. Ensure there is no water inside fuel
tank.
CAUTION: Should any water be trapped inside
fuel tank, severe internal damage will occur to
the fuel injection system (if so equipped).
Do not drain fuel system.
CAUTION: Fuel stabilizer should be added prior
to engine lubrication to ensure carburetor pro-
tection against varnish deposit.
WARNING
Fuel is flammable and explosive under cer-
tain conditions. Always work in a well ven-
tilated area. Do not smoke or allow open
flames or sparks in the vicinity. Fuel tank
may be pressurized, slowly turn cap when
opening. Never use an open flame to check
fuel level. When fueling, keep vehicle level.
Do not overfill or top off the fuel tank and
leave vehicle in the sun. As temperature
increases, fuel expands and might overflow.
Always wipe off any fuel spillage from the
vehicle. Periodically inspect fuel system.
DRIVE SYSTEM
Drive and Driven Pulley
After inspection and interior cleaning of pulleys,
spray BOMBARDIER LUBE (P/N 293 600 016)
on
sheaves. Do not reinstall drive belt
.
Brake Fluid
Replace brake fluid, refer to DRIVE SYSTEM sec-
tion.
4 mmr2005-061

Содержание

Скачать