Home
Главная
Ski-Doo
Снегоход
Ski Doo MX Z 2005
Инструкция по эксплуатации Страница: 884

Ski-Doo Ski Doo MX Z 2005 [884/1429] Cooling system

Section01MAINTENANCE

Subsection 02 (STORAGE)

Crank slowly 2 or 3 revolutions to lubricate cylin-

ders.

Reinstall the spark plugs and the outlet primer

hose or air silencers.



WARNING

This procedure must only be performed in a

well-ventilated area. Do not run engine dur-

ing storage period.

COOLING SYSTEM

4-Stroke Models

Antifreeze should be replaced for the storage pe-

riod to prevent antifreeze deterioration.

Make sure to perform an antifreeze density test.

Cooling system must be filled with BOMBARDIER

premixed coolant (P/N 293 600 038) or with dis-

tilled water antifreeze solution (50% distilled wa-

ter, 50% antifreeze).

CAUTION: Improper antifreeze mixture might

allow freezing of the liquid in the cooling sys-

tem if vehicle is stored in area where freezing

point is reached. This would seriously damage

the engine. Failure to replace the antifreeze

for storage may allow its degradation that

could result in poor cooling when engine will

be used.

Refer to COOLING SYSTEM section.

ENGINE OIL CHANGE AND FILTER

4-Stroke Models

Change engine oil and filter. Refer to LUBRICA-

TION in ENGINE section.

COUNTERSHAFT LUBRICATION

Driven pulley and brake disc must be floating on

the countershaft for efficient operation. Lubricate

with anti-seize lubricant (P/N 293 800 070).

CAUTION: Do not lubricate excessively as

lubricant could contact and soil brake pads

and/or drive belt.

PULLEY PROTECTION

After inspection and interior cleaning of pulleys,

spray BOMBARDIER LUBE (P/N 293 600 016) on

sheaves. Do not reinstall drive belt.

VEHICLE PROTECTION

Protect the vehicle with a cover to prevent dust

accumulation during storage.

CAUTION: The snowmobile has to be stored

in a cool and dry place and covered with an

opaque but ventilated tarpaulin. This will pre-

vent sun rays and grime from affecting plastic

components and vehicle finish.

Lift rear of vehicle until track is clear of the ground.

Install on a snowmobile mechanical stand.

NOTE: Do not release track tension.

RAGS IN AIR INTAKE AND

EXHAUST SYSTEM

Block air intake hole and exhaust system hole us-

ing clean rags.

mmr2005-003 5

Ski-Doo Ski Doo MX Z 2005 [884/1429] Cooling system

Содержание

Похожие устройства