Ski-Doo Ski Doo MX Z 2005 [1368/1429] Warning

Ski-Doo Ski Doo MX Z 2005 [1368/1429] Warning
Section 09 REAR SUSPENSION
Subsection 05 (TRACK)
A29F14A
12
3
TYPICAL
1. Adjustment screw
2. Loosen lock nut (on so equipped models)
3. Loosen screw
Retighten retaining screws and lock nuts (on so
equipped models).
Check track alignment as described below.
Alignment
WARNING
Before checking track alignment, ensure that
the track is free of all particles which could
be thrown out while track is rotating. Keep
hands, tools, feet and clothing clear of track.
Ensure no one is standing in close proximity
to the snowmobile. Never rotate track at high
speed.
Start the engine and accelerate slightly so that
track barely turns. This must be done in a short
period of time (15 to 20 seconds).
Check that the track is well centered; equal
distance on both sides between edges of track
guides and slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
To adjust track alignment:
Remove the tether cord cap.
Loosen rear idler wheel retaining screws.
Loosen the lock nuts (on so equipped models).
Tighten the adjustment screw on side where
the slider shoe is the farthest from the track
insert guides.
A01F0BA
1
2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
Tighten lock nuts (some models only) and retaining
screws.
WARNING
If lock nuts are not tightened properly, the ad-
justing screws could loosen causing the track
to become extremely loose and, under some
operating conditions, allow the idler wheels
to climb over the track lugs forcing the track
against the tunnel causing the track to lock.
Properly tighten wheel retaining screws, oth-
erwise wheel may come off and cause track
to lock.
mmr2005-052 513

Содержание

Скачать